3D Printing#
3D Printer - Big Builder - Dual feed (RF lab)#
http://3dprinter4u.nl/shop/3d-printers/big-builder-dual-feed-extruder/
Before you start printing you need to do the following steps:
Check the paper tape mounted on the bed, change or clean if necessary
Prepare - Auto Home
Prepare - Preheat 210
Use CURA to load and configure your file before printing. You can also find the CURA manual on the desktop.
Reduce shifting by reducing the print & travel speed to 50mm/s.
Useful information for troubleshooting: http://support.3dverkstan.se/article/23-a-visual-ultimaker-troubleshooting-guide
Modix Big-60 V2 - Dual feed (RF lab)#
Spec |
Description |
---|---|
Model |
Raspberry Pi |
OS |
OctoPrint |
Hostname |
|
Credentials |
The Modix 3D printer is remotely controlled using OctoPrint. To access the control interface go to the hostname and use the credentials provided above.
OctoPrint configuration
Very small 3D printer (in technician’s office)#
bring the technicians a USB stick with model in STL
Small 3D printer (in Frederic Lesage’s lab)#
Instructions (please read!): Using the 3D Printer
username/password: ask Julien jcohen@polymtl.ca
Video: https://www.dropbox.com/s/fxt8sj831osqfo0/instructions_3dprinter.mp4